Power and Energy
Dynamic data for frequency control with continuous UFLS and LCFB1
This dataset is supplementary material to the draft 'Continuous Under-Frequency Load Shedding Scheme for Power System Adaptive Frequency Control' submitted to IEEE Transactions on Power Systems. Authors of the draft are: Changgang Li, Member, IEEE, Yue Wu, Yanli Sun, Hengxu Zhang, Member, IEEE, Yutian Liu, Senior Member, IEEE, Yilu Liu, Fellow, IEEE, and Vladimir Terzija, Fellow, IEEE
- Categories:
980 Views
Test systems are important tools and benchmark for power system research. Currently, there is a lack of standard test systems for modern transmission expansion planning (TEP) research, especially under high variable renewable energy (VRE) penetrations. This paper describes a 38-bus test system named the HRP-38 system dedicated to TEP. “HRP” stands for high renewable penetration. The objective of establishing such a system is to provide a consistent platform for different TEP methods to be tested and compared.
- Categories:
5544 Views
This dataset contains data used for case studies in paper titled “Towards Flexible Risk-Limiting Operation of Multi-Terminal HVDC Grids with Vast Wind Generation” submitted to IEEE Transactions on Sustainable Energy.
- Categories:
250 Views
These two data sets are the generation and load profiles for a modified IEEE 123-node case and Nanji case.
- Categories:
526 Views
This dataset contains daily maximum load data with the average demand, customer count and PV capacity at two substations Arkana and Muchea, Western Australia used in the accepted IEEE Transactions on Power Systemspaper titled “The Use of Extreme Value Theory for Forecasting Long-Term Substation Maximum Electricity Demand” by Li and Jones (2019). The dataset spans from 01/01/2008 to 30/06/2022, part history (01/01/2008 to 16/09/2018) and part forecast (17/09/2018 to 30/06/2022). The dataset is beneficial to various research such as long-term load forecast.
- Categories:
730 Views
This dataset contains daily maximum load data with the average demand, customer count and PV capacity at two substations Arkana and Muchea, Western Australia used in the accepted IEEE Transactions on Power Systemspaper titled “The Use of Extreme Value Theory for Forecasting Long-Term Substation Maximum Electricity Demand” by Li and Jones (2019). The dataset spans from 01/01/2008 to 30/06/2022, part history (01/01/2008 to 16/09/2018) and part forecast (17/09/2018 to 30/06/2022). The dataset is beneficial to various research such as long-term load forecast.
- Categories:
204 Views
This dataset contains daily maximum load data with the average demand, customer count and PV capacity at two substations Arkana and Muchea, Western Australia used in the accepted IEEE Transactions on Power Systemspaper titled “The Use of Extreme Value Theory for Forecasting Long-Term Substation Maximum Electricity Demand” by Li and Jones (2019). The dataset spans from 01/01/2008 to 30/06/2022, part history (01/01/2008 to 16/09/2018) and part forecast (17/09/2018 to 30/06/2022). The dataset is beneficial to various research such as long-term load forecast.
- Categories:
247 Views
The LCL filter design procedure presented here is similar to that presented in references [1] and [2]. Here, the procedure is presented in a step-by-step way and the simulation file is freely available on http://busarello.prof.ufsc.br/
[1] Teodorescu, R. ; Liserre, M. ; Rodriguez, P. . Grid Converters for Photovoltaic and Wind Power Systems. 2011, Wiley.
- Categories:
687 Views
The DFT and FFT are used mainly to obtain the amplitude of a harmonic component from a periodic signal containing several harmonics. For instance, it is desired to know the 180 Hz harmonic amplitude from a signal. Then, the DFT and FFT are the best choices to do that.
- Categories:
689 Views
The research subject of this papper is five electrical quantities, the phase current of abnormal phase IL, the sheath current of initial terminal Iss, the sheath current of last end Ise and other two phase currents IO1, IO2.
- Categories:
274 Views