Power and Energy
This dataset could be used to reproduce the results of the AVM model proposed in the paper "Unified Modeling and Analysis of the Dual-Control High-Speed Response Brushless Excitation System of Synchronous Generators".
- Categories:
178 Views
This file is from the software of PSS/E developed by Siemens PTI, desribing the load flow data of one 1648 bus system.
- Categories:
1102 Views
An effective use of electrochemical Energy Storage Systems (ESSs) is mandatory for improving the performances of next generation electric vehicles and hybrid electric vehicles, as well as of smart grid and microgrid systems.
- Categories:
16865 Views
The fifth-generation cellular networks (5G)has been proposed as a solution for the accelerating growth in data traffic. As part of 5G, millimetre-wave (mmWave) is suggested as one of the potential spectrum candidates due to the vastly available bandwidth. Accordingly, both indoor and outdoor propagation measurements on mmWave have been widely conducted over the recent years. These field measurements were heavily dependent on utilizing expensive channel-sounders and tools.
- Categories:
537 Views
Photovoltaic (PV) power generation forecasting is an important topic in field of power system, energy conversion and smart grid construction. The PV power generation has the properties of randomness and volatility is due to the variability of solar irradiance, temperature and other meteorological factors. In order to reduce the volatility, accurate PV power generation forecasting techniques are demanded.
- Categories:
1951 Views
RSSI-Dataset
The RSSI-Dataset provides a comprehensive set of Received Signal Strength Indication (RSSI) readings from within two indoor office buildings. Four wireless technologies were used:
- Zigbee (IEEE 802.15.4),
- WiFi (IEEE 802. 11),
- Bluetooth Low Energy (BLE) and
- Long Range Area-Wide Network (LoRaWAN).
For experimentation Arduinos Raspberry Pi, XBees, Gimbal beacons Series 10 and Dragino LoRa Shield were also used.
- Categories:
1703 Views
This is the data for the grounding current of a radial structured distribution network, when subject to a single-phase earth fault.
- Categories:
174 Views
Research on Optimizing the Integration of Renewable Energy Sources into the Electrical Power Systems
In this project one model the photovoltaic and wind power sources in order to analyze how to optimally integrate them in the electrical power systems. Integration requirements like transient regimes associated with fault occurrence, identification of the electrical power systems responsible for disturbances, and optimization of the integration are focus points of the research.
- Categories:
930 Views
This is the Smulation Data for Power System State Estimation.
- Categories:
534 Views